Now that was much more routing time that I thought. Because of the 2 sheets of HDF, I had to transfer the first layout to the second, only without some of the "out-cuts" trying to keep as much thickness as possible.
 |
| Keeping as much material as possible... |
 |
| Luckily this cheap saw is adjustable in all directions, all nuts and bolts... |
 |
| Only problem so far is the knife.. But I guess I will adjust that (make it smaller) because making the cut-out to change the saw blade bigger means less strength. |
 |
And now it's all about little adjustments to get the new top on to this 1 millimeter thick "steel"..
Maybe that's something to make a bit stronger to.. |
 |
| Routing and grey HDF... not a good combination if you want to keep your workshop clean... |
No comments:
Post a Comment